List all wireless devices:
Disable WiFi controller:
rfkill block wifi
rfkill block bluetooth
The co-processor (BGM111) SWDIO interface is exposed to the CM3L/CM3+L via bit-banged GPIO pins. This means that the co-processor can be flashed from the CM3L/CM3+L via, for example, openOCD. A reference can be found here.
The balenaFin sports a very common I2C RTC module that is well known, supported, and documented within the Raspberry Pi ecosystem: the DS1307.
There are plenty of guides on how to interact with the chip, including the following:
balenaFin v1.1 sports a PCA9633 LED controller. This controller is mainline supported and enumerates the 3 color LEDs as sysfs led class devices in
$COLOR can be
green. This interface allows to set each color brightness or register a kernel trigger to each color.
echo $BRIGHTNESS > /sys/class/leds/pca963x\:$COLOR/brightnesswhere
$BRIGHTNESSis a value between 0 (off) and 255 (100%) and
echo $TRIGGER > /sys/class/leds/pca963x\:$COLOR/triggerwhere
$TRIGGERis a supported kernel trigger (like
mmc0that will make the LED behave the same as the green ACT led of the Raspberry Pi) and
dt-blob.binfile in the boot partition of the board with this file. You can use etcher for mounting the balenaFin boot partition attached via the PRG cable (and no PSU attached!) or you can edit the OS image before flashing it onto the balenaFin.
CAM1position. This operation needs to be performed with the device powered OFF!
This device sports 9 status LEDs varying from power, eMMC, ethernet, WiFi, WAN, etc. There is a switch which allows users to toggle them all on and off via software.
echo 511 > /sys/class/gpio/export
echo "out" > /sys/class/gpio/gpio511/direction
echo 0 > /sys/class/gpio/gpio511/value # turn off
echo 1 > /sys/class/gpio/gpio511/value # turn on
We are working on identifying and documenting cards known to work out of the box on the board. If you plan on adding LTE capability to the device, we suggest the Quectel EC21-XX Mini PCIe: the card is known to work out of the box, hence only APN configuration is required. On balenaOS (2.0.0+) you do so by adding a NetworkManager profile in the boot partition under the "system-connections" folder. You can find more info about this on our docs at: https://balena.io/docs/deployment/network/2.0.0/#cellular-modem-setup.
Disabling RF activity on mPCIe radio cards
echo 508 > /sys/class/gpio/export
echo "out" > /sys/class/gpio/gpio508/direction
echo 1 > /sys/class/gpio/gpio508/value # mPCIe on
echo 0 > /sys/class/gpio/gpio508/value # mPCIe off
echo 507 > /sys/class/gpio/export
echo "out" > /sys/class/gpio/gpio507/direction
echo 1 > /sys/class/gpio/gpio507/value # HDMI off
echo 0 > /sys/class/gpio/gpio507/value # HDMI on